Dodge Journey: Coil, ignition

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...

Removal
2.4L Fig. 11: Identifying Ignition Coil Electrical Connectors NOTE: Prior to removing coil, spray compressed air around coil top to make sure no dirt drops into the spark plug tube. The ...

See also:

Disassembly
Fig. 229: Snap Ring At Output Shaft 1. Using Snap Ring Pliers (1) remove the snap ring (2) from the output shaft # 2. Fig. 230: Bearing From Cluster Shaft 2. Using a press, blocks, Bearing Sp ...

Installation
1. Guide the trailing end of the parking brake cable along the inboard side of the axle trailing arm up to the rear brake caliper. Make sure the cable is routed between the brake line and the tra ...

Removal, Installation
REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negati ...

0.0082