Dodge Journey: Sensor, mass air flow (MAF)

Removal

Emissions Control
Fig. 10: MASS AIR FLOW SENSOR

1. Disconnect air flow sensor electrical connector (4).

2. Remove constant tension clamps (1), (2) securing the air flow sensor (3).

3. Remove air flow sensor (3) from hoses.

Installation

Emissions Control
Fig. 11: MASS AIR FLOW SENSOR

1. Note the arrow direction on the sensor and correctly position the air flow sensor (3) to hoses.

2. Install constant tension clamps (1), (2) to secure air flow sensor (3) to hoses.

3. Connect air flow sensor electrical connector (4).

    Pump, air
    Description The air injection pump is located on the left side of the engine compartment. The pump is operated by an internal electrical motor and is mounted to a bracket by rubber isolators. An ...

    Tube, air pump, inlet
    Description The air pump inlet tube is located on the left side of the engine compartment. The tube attaches to the air injection pump using a quick connect style fitting. The other end of the tub ...

    See also:

    Installation
    CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant oil level will prevent the A/C system fro ...

    Description, Diagnosis and Testing
    DESCRIPTION The inner joints of both half shaft assemblies are tripod joints. The outer joints of both assemblies are Rzeppa Joints. The tripod joints are true constant velocity (CV) joint assembl ...

    Control, A/C and heater, rear
    DESCRIPTION The A/C-heater controls allows the driver and front seat passenger and the intermediate seat passengers the ability to regulate air temperature as well as fan speed for the rear heat ...


    0.018