Ensioner, belt

Removal 2.4L ENGINE Fig. 36: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY ...

Bottle, coolant recovery

Description NON-PRESSURE Fig. 52: NON-PRESSURE COOLANT RECOVERY CONTAINER - COOLANT RECOVERY CONTAINER - OVERFLOW HOSE - RADIATOR PRESSURE CAP The coolant recovery system used on 2.4L e ...

See also:

Disassembly
Fig. 229: Snap Ring At Output Shaft 1. Using Snap Ring Pliers (1) remove the snap ring (2) from the output shaft # 2. Fig. 230: Bearing From Cluster Shaft 2. Using a press, blocks, Bearing Sp ...

Sensor, speed, output
DESCRIPTION Fig. 378: Identifying Output Speed Sensor - OUTPUT SPEED SENSOR The Output Speed Sensor (1) is a two-wire magnetic pickup device that generates an AC signal as rotation occurs ...

Switch, heated seat
DESCRIPTION Fig. 10: Locating Accessory Switch Bank Module Two heated seat switches are located in the center stack of the instrument panel. The switches are located on the outer edges of the A ...