Cleaning, Inspection

CLEANING Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information . Run engine with radiator cap installed until upper radiator hose is ho ...

Belt, serpentine

Description Fig. 15: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY - WATE ...

See also:

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fat ...

Removal
BULB Each rear lamp unit for this vehicle consists of two pieces. An outer rear lamp unit that is secured at the rear of each quarter panel includes bulbs for the park (or tail) lamps, the brake ( ...