Dodge Journey: Cleaning, Inspection

CLEANING

Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information .

Run engine with radiator cap installed until upper radiator hose is hot. Stop engine and drain water from system.

If water is dirty; fill, run, and drain system again, until water runs clear. Refill cooling system with a 50/50 mixture of the recommended ethylene-glycol and distilled water.

INSPECTION

After performing a cleaning/flush procedure, inspect all hoses, clamps and connections for deterioration and leaks. Inspect radiator and heater core for leaks.

SPECIFICATIONS

FILL VOLUMES

TORQUE

SPECIAL TOOLS

Cooling
Fig. 8: BELT TENSION GAUGE ADAPTER - 8371

Cooling
Fig. 9: HOSE CLAMP PLIERS 8495

Cooling
Fig. 10: HOSE CLAMP PLIERS 6094

Cooling
Fig. 11: FILLING AID FUNNEL 8195

Cooling
Fig. 12: COOLING SYSTEM TESTER 7700

Cooling
Fig. 13: COOLANT REFRACTOMETER 8286

Cooling
Fig. 14: RELEASE TOOL 8875A

    Standard procedure
    DRAINING When servicing the cooling system, it is essential that coolant does not drip onto the accessory drive belts and/or pulleys. Shield the belts with shop towels before working on the coolin ...

    See also:

    Sensor, variable line pressure
    DESCRIPTION Fig. 390: Identifying Variable Line Pressure Sensor - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT - SC ...

    Lifter(s), hydraulic
    Diagnosis and Testing DIAGNOSIS AND TESTING - HYDRAULIC LASH ADJUSTER NOISE DIAGNOSIS Proper noise diagnosis is essential in locating the source of a NVH complaint. Locating a lash adjuster (tappe ...

    Description, standard procedure
    DESCRIPTION Fig. 163: Engine Block & Crankshaft - MAIN CAP BOLT-VERTICAL - MAIN CAP - MAIN BEARING-LOWER - MAIN BEARING-UPPER - MAIN CAP BOLT - HORIZONTAL - CYLINDER BLOCK - CRA ...

    0.014