Description, Operation

DESCRIPTION Fig. 1: COOLING SYSTEM - OVERVIEW - WINDSHIELD WASHER RESERVOIR - UPPER SUPPORT - FAN SHROUD - FAN MOTOR - LOWER RADIATOR HOSE The cooling system consists of an engine co ...

Preliminary checks

ENGINE COOLING SYSTEM OVERHEATING Establish what driving conditions caused the complaint. Abnormal loads on the cooling system such as the following may be the cause: Prolonged idle Very hig ...

See also:

Installation
Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...

Removal
LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...