Cover(s), engine timing

Removal Fig. 349: FRONT SPLASH SHIELDS 1. Disconnect and isolate negative battery cable. 2. Drain cooling system. 3. Remove coolant pressure container. 4. Remove right front wheel and bel ...

Description, Operation

DESCRIPTION Fig. 1: COOLING SYSTEM - OVERVIEW - WINDSHIELD WASHER RESERVOIR - UPPER SUPPORT - FAN SHROUD - FAN MOTOR - LOWER RADIATOR HOSE The cooling system consists of an engine co ...

See also:

Assembly
Fig. 97: Installing Output Bearing Cups - OUTPUT BEARING CUPS - WRENCHES - INSTALLER - 5050A CAUTION: The cooler bypass valve must be replaced if transaxle failure has occur ...

ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets located in the center console below the radio. The power outlet on the top has power available when the ignition switch in the ON or ACC position. ...

Cable, gearshift control
REMOVAL Fig. 161: Shift Cables & Bracket 1. Remove the shifter. 2. Raise hood. 3. Remove the resonator. 4. Remove engine cover. 5. Remove air cleaner assembly. 6. Disconnect ne ...