Valve, oil pressure relief

Removal Fig. 285: Oil Pressure Relief Valve - RELIEF VALVE - SPRING - RETAINER CAP 1. Remove the oil pan. 2. Remove the pressure relief valve (1) by remove the threaded retaining cap ...

Manifold, exhaust, crossover

Removal Fig. 287: Belly Pan - belly pan fasteners - belly pan 1. Remove the belly pan (2). Fig. 288: Exhaust Extension Pipe 2. Remove the fasteners (1), and remove the exhaust extensio ...

See also:

FUSES
Totally Integrated Power Module The Totally Integrated Power Module (TIPM) is located in the engine compartment near the air cleaner assembly. This center contains fuses and relays. Totally Inte ...

Seal, crankshaft oil, front
Removal Fig. 212: Crankshaft Front Oil Seal - Removal - SPECIAL TOOL 6771 1. Remove crankshaft vibration damper. 2. Install Special Tool 8194, Insert into crankshaft nose. Remove seal us ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...