Dodge Journey: Switch, oil pressure

Description

The engine oil pressure switch is located on the right side of the engine block. The switch screws into the engine main oil gallery. The normally closed switch provides an input through a single wire to the low pressure indicator light on the instrument cluster.

Removal

1. Raise vehicle on hoist.

2. Remove heat shield that covers oil pressure switch.

3. Disconnect oil pressure switch electrical connector.

4. Position an oil collecting container under switch location.

5. Remove switch by unscrewing from the engine block.

Installation

1. Apply Mopar Thread Sealant to the switch threads.

2. Install oil pressure switch.

3. Connect electrical connector.

4. Install oil pressure switch heat shield.

5. Lower vehicle.

6. Start engine and check for leaks.

7. Check engine oil level and adjust as necessary.

    Pump, engine oil
    Removal Fig. 275: Oil Pump & Pick-up Tube - BOLTS - O-RING - PICK-UP TUBE - BOLT - OIL PUMP NOTE: The oil pump pressure relief valve can be serviced by removing the oil pan ...

    Valve, oil pressure relief
    Removal Fig. 285: Oil Pressure Relief Valve - RELIEF VALVE - SPRING - RETAINER CAP 1. Remove the oil pan. 2. Remove the pressure relief valve (1) by remove the threaded retaining cap ...

    See also:

    Description
    Fig. 46: Left Multifunction Switch The left (lighting) multi-function switch is located on the left side of the steering column, just below the steering wheel. This switch is the primary contro ...

    Disassembly
    NOTE: Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When disassembling, each part should be washed in a suitable solvent, then dried by comp ...

    Fascia, rear
    REMOVAL Fig. 15: Push Pins 1. Open the hatch. 2. Remove the 6 pushpins (1) securing the fascia (2). Fig. 16: Rivets 3. Remove the rivets (2) and the Torx screw (3) around the wheel well for ...

    0.0085