Insulator, engine mount, right

Removal Fig. 243: Belly Pan 1. Remove the belly pan (2). Fig. 244: Right Engine Mount 2. Lower vehicle. Remove the load on the engine motor mounts by carefully supporting the engine assembly ...

Description, Operation, Diagnosis and Testing

DESCRIPTION The lubrication system is a full-flow filtration, pressure feed type. The oil pump body is mounted to the engine block. The pump inner rotor is driven by the crankshaft. A structural w ...

See also:

Switch, backup lamp
DESCRIPTION Fig. 43: Backup Lamp Switch Vehicles equipped with a manual transmission (2) have a normally open, spring-loaded plunger type backup lamp switch (1). Vehicles with an optional elect ...

Clutch air pressure tests
Fig. 6: Identifying Air Pressure Test Plate Tool 6056 - AIR PRESSURE TEST PLATE TOOL 6056 - ACCUMULATORS Inoperative clutches can be located using a series of tests by substituting air pr ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...