Dodge Journey: Adjustments
ADJUSTMENT
The right and left support assemblies are slotted to allow for right/left drive train adjustment in relation to drive shaft assembly length.
Check and reposition right and left engine support assemblies as required. Adjust drive train position, if required, for the following conditions:
- Drive shaft distress:
- Any front end structural damage (after repair).
- Support Assembly replacement.
ENGINE SUPPORT ADJUSTMENT
1. Remove the load on the engine motor mounts by carefully supporting the engine and transmission assembly with a floor jack.
2. Loosen the right engine support assembly vertical fasteners.
3. Loosen the left engine support assembly vertical bolts.
4. Pry the engine right or left as required to achieve the proper drive shaft assembly length.
5. Tighten right engine support assembly vertical bolts to 61 N.m (45 ft. lbs.). and tighten left engine support assembly bolts to 61 N.m (45 ft. lbs.).
6. Recheck drive shaft length.
Engine mounting
...Insulator, engine mount, front
Removal 1. Raise vehicle. Fig. 222: Belly Pan - belly pan fasteners - belly pan 2. Remove the belly pan (2). Fig. 223: Front Engine Mount Through Bolt 3. Remove front mount to bracket ...See also:
Unit, heater
DESCRIPTION
Fig. 323: Positive Temperature Coefficient Heater - Description
NOTE: LHD model shown. RHD model similar.
An electric positive temperature coefficient (PTC) heater unit (1) is us ...
ELECTRONIC VEHICLE INFORMATION CENTER (EVIC) — IF EQUIPPED
The Electronic Vehicle Information Center (EVIC) features
a driver-interactive display. It is located in the
instrument cluster below the fuel and temperature
gauges. Vehicles equipped with steerin ...
ELECTRONIC SPEED CONTROL — IF EQUIPPED
When engaged, the Electronic Speed Control takes over
the accelerator operation at speeds greater than 25 mph
(40 km/h).
The Electronic Speed Control lever is located on the right
side of the stee ...