Valves, intake and exhaust

Description The valves are made of heat resistant steel, and have chrome plated stems to prevent scuffing. The four valves per cylinder (two intake and two exhaust) are actuated by roller rocker a ...

Description, standard procedure

DESCRIPTION Fig. 163: Engine Block & Crankshaft - MAIN CAP BOLT-VERTICAL - MAIN CAP - MAIN BEARING-LOWER - MAIN BEARING-UPPER - MAIN CAP BOLT - HORIZONTAL - CYLINDER BLOCK - CRA ...

See also:

Lines, A/C underbody, extension
Description Fig. 310: Underbody A/C Extension Lines Description Models equipped with the rear heating-A/C system use metal lines attached to the vehicle underbody to carry refrigerant and engin ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may result in possible se ...

ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle. Drive moderately during the first 300 mi (500 km). After the initial 60 mi (100 km), sp ...