Body, air cleaner

REMOVAL 1. Disconnect negative battery cable. Fig. 87: Inlet Air Temperature Sensor Electrical Connector 2. Disconnect inlet air temperature sensor electrical connector (3). 3. Disconnect fres ...

Description, Diagnosis and Testing

DESCRIPTION Fig. 91: Cylinder Head, Valves & Springs - VALVE KEEPER - SPRING RETAINER - VALVE KEEPER - VALVE SPRING-EXHAUST - SPRING RETAINER - VALVE STEM SEAL - VALVE-EXHAUST ...

See also:

Installation
LEFT-HAND DRIVE 1. Clean any debris off the mating surfaces of the HCU and ABM. CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant. ...

Module, heated seat
DESCRIPTION Fig. 35: Locating Heated Seat Module The heated seat module (2) is located under the driver front seat. It has a single electrical connector (1) and a push pin style retainer that s ...

Preliminary checks
ENGINE COOLING SYSTEM OVERHEATING Establish what driving conditions caused the complaint. Abnormal loads on the cooling system such as the following may be the cause: Prolonged idle Very hig ...