Electronically controlled clutch

REMOVAL NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues. Fig. 95: Removing /Installing Propell ...

Battery System

...

See also:

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

Description, Diagnosis and Testing
DESCRIPTION This vehicle is equipped with either an equal length halfshaft system, consisting of short halfshafts on both sides with an intermediate drive shaft on the right side, or an unequal le ...

Duct, floor distribution, rear
REMOVAL Fig. 159: Rear Floor Distribution Duct 1. Remove right quarter trim panel. 2. Remove the push-pin retainer (2) that secures the rear floor distribution duct (1) to the right inner qu ...