Removal, Installation

REMOVAL Fig. 54: Removing /Installing Propeller Shaft CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while o ...

Operation, Diagnosis and Testing

OPERATION The primary benefits of All Wheel Drive are: Superior straight line acceleration, and cornering on all surfaces Better traction and handling under adverse conditions, resulting in ...

See also:

Assembly
NOTE: If the coil spring has been removed from the spring compressor, proceed with the next step, otherwise, proceed with 3. NOTE: To determine the flat coil end of the coil spring for the ...

Installation
Fig. 186: Rear Heater AC Housing Removal/Installation NOTE: MTC rear heater-A/C system shown. ATC system similar. 1. Position the rear heater-A/C housing (1) into the vehicle and align the ...

Removal
Fig. 56: BRAKE PEDAL HOLDING TOOL 1. Using a brake pedal holding tool as shown, depress the brake pedal past its first one inch (25 mm) of travel and hold it in this position. This will isolate ...