With intermediate shaft

NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...

Without intermediate shaft

NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...

See also:

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

MEDIA CENTER 230 (REQ) — AM/FM STEREO RADIO AND 6–DISC CD/DVD CHANGER (MP3/WMA AUX JACK)
NOTE: The radio sales code is located on the lower right side of the radio faceplate. REQ Radio Operating Instructions - Radio Mode NOTE: The ignition switch must be in the ON or ACC position t ...

Actuator, mode door, rear
DESCRIPTION Fig. 51: Rear Actuator Description The mode door actuator (1) for the rear heater-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear mode door actuator i ...