Installation

NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

Removal

LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...

See also:

Inspection, adjustments
INSPECTION Inspect the exhaust pipes, catalytic converters, muffler, and resonators for cracked joints, broken welds and corrosion damage that would result in a leaking exhaust system. Inspect the ...

Seal, crankshaft oil, front
Removal Fig. 212: Crankshaft Front Oil Seal - Removal - SPECIAL TOOL 6771 1. Remove crankshaft vibration damper. 2. Install Special Tool 8194, Insert into crankshaft nose. Remove seal us ...

Actuator, mode door, front
DESCRIPTION Fig. 12: Blend Door Actuators The mode door actuator (1) for the heating-A/C system is a reversible, 12-volt Direct Current (DC) servo motor, which is mechanically connected to the ...