Dodge Journey: Pads, brake, front

Installation
LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

See also:

Module, glow plug
DESCRIPTION Fig. 23: Locating Diesel Glow Plug Control Module The glow plug control module is mounted to the fuel filter/water separator bracket, and is controlled by the engine control module. ...

Installation
Fig. 32: Brake Booster Vacuum Hose 1. Position engine/transaxle assembly under vehicle and slowly lower vehicle in short length spans. Inspect at each interval for potential engine or transaxle ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

0.0098